CLICK HERE and either fill the form out or give us a call, and we will be happy to assist you after assessing your exact needs.
32oz spray bottle (pre mixed formula), 1 gallon, 5 gallon, 55 gallons or IBC Totes.
207® is a uniquely formulated single step process that effectively removes both water-soluble and non-water-soluble microscopic contaminants. It is both environmentally friendly and easy to use by being applied after an abrasive blast and before protective coatings are applied.
- Not an inhibitor or film former
- Single step application
- Non-hazardous
- Improves adhesion
- Non-flammable
- Water based
- Significantly prevents “rust back”
- Fast drying
- Does not foul lines or pumps
- Does not require deionized water
- No need to coat same day
207® greatly enhances traditional surface preparation standards, with the elimination of the corrosion mechanism. It also addresses the molecular cause of corrosion and thus decreases the amount of time the asset would be out of service and immensely lessens future corrosion damage to the asset
No. Visual, non-visual, microscopic and MIC (microbiological influenced corrosion) surface contaminants are the key accelerant of corrosion. 207® decontaminates the surface at a molecular level by eliminating these microscopic corrosive elements that are a major cause of coating failures.
The substrate of ALL Contaminates, including Biofilm, MIC, Iron Chlorides, Sulfates, Nitrates, and others at the molecular level. Visual, non-visual, microscopic and MIC (microbiological influenced corrosion) surface contaminants are the key accelerant of corrosion. 207® decontaminates the surface at a molecular level by eliminating these microscopic corrosive elements that are a major cause of coating failures.
With a non-forming Oxide Layer by the 207®, you will not have any immediate flash rust forming prior to the application of a protective coating. 207® will typically maintain a visual standard from three days or longer depending on immediate environmental conditions
Our patented formula creates a non-forming bond at the coating to substrate interface. Preventive Maintenance is achieved with CleanWrx Solutions™ 207® by the chemical formation of an Amorphous Oxide Layer. This oxide layer formed on the substate allows for electron sharing thus the coating is truly bonded to the substrate, which greatly decreases asset down time and increases service run time.
Using 207® is a one step process, no purified water is needed. 207® can work with any type of potable water whether it’s hard or soft. We do have suggestions on use, but no need to truck in certain water unless potable water is not available.